Mobile Motorcycle Service AvailableOpen 24 Hours — 7 Days a Week

Services

Motorcycle service and repair, front wheel to rear

Scheduled maintenance, mechanical repair and fault diagnosis on carbureted and fuel-injected motorcycles, from the shop at Schilling Ct, Whitby, ON L1N 8X7. Each job includes an inspection of the surrounding systems so small problems get caught early.

Mobile Motorcycle Service Available

Can't bring your bike to us? Mobile service is available for eligible repairs and maintenance.

Blue Suzuki sport bike on stands in the 2WheeledMechanic workshop
Fuel pump assembly inspected during motorcycle service at 2WheeledMechanic

Real Work

Parts diagnosed, not just replaced

Every service starts with a proper inspection. Components like fuel pumps, stators and rectifiers are tested first so you only pay for what actually needs fixing.

Brake Service & Repair

Pad and rotor replacement, caliper rebuilds, brake line inspection and full fluid bleed for firm, predictable stopping power.

Carburetor Cleaning

Full teardown, cleaning of jets and passages, new gaskets, float height and mixture set for clean idle and throttle response.

Electrical Repair

Fault tracing on charging circuits, wiring harnesses, switches, fuses, lighting and starting systems with voltage-drop testing.

Oil Changes

Drain and refill with the correct grade oil, new filter and crush washer, level set and a quick leak and fastener check.

Steering & Suspension Repair

Fork seal and oil service, shock and linkage inspection, steering head bearing replacement, sag and preload adjustment.

Tire Service

Mounting, balancing, stem replacement, puncture assessment and pressure setting, plus wheel bearing and rim condition checks.

Spark Plug Service

Plug removal and reading, gap setting, coil and cap resistance testing, torque-to-spec installation of correct-heat-range plugs.

Chain Service

Cleaning, lubrication, slack and alignment adjustment, wear measurement, plus sprocket inspection and chain or sprocket set replacement.

Engine Diagnostics

Fault code scanning, compression and leak-down testing, fuel pressure and sensor checks to isolate the actual cause before parts go on.

Pre-Purchase Inspections

Point-by-point mechanical and electrical assessment with frame, fluid and wear findings written up so you know exactly what you are buying.

Engine Tune-Ups

Throttle body or carb synchronisation, idle and timing verification, compression check, with filters and plugs refreshed as needed.

Coolant Flush

Old coolant drained, system flushed, fresh coolant filled and bled, with hose, cap, radiator and thermostat condition checked.

Clutch Replacement

Friction and steel plate replacement, spring and basket inspection, cable or hydraulic actuation set for clean engagement.

Stator / Alternator Service

AC output and resistance testing, insulation checks, stator or alternator replacement to restore reliable charging output.

Stator / Rectifier Service

Regulator-rectifier diagnosis, connector and ground repair, replacement of failed units to stop overcharging and flat batteries.

Not sure what the bike needs?

Describe the symptoms and diagnostics will pinpoint the cause before any parts are ordered.